Guernsey, Jersey, Ireland, Belgium, Netherlands, Luxembourg, Norway, France, Germany, Spain, Austria, Denmark, Portugal, Italy, Slovakia, Sweden, Slovenia, Hungary, Estonia, Poland, Czech Republic, Finland, Lithuania, Bulgaria, Latvia, Romania, Croatia, Greece
1 x Single Eames Herman Miller or Vitra DCM Plywood Chair replacement rubber shockmount.
DCM Chair Shockmounts are bigger than standard fiber chairs and are made from the original rubber compound for the most authentic replacement part.
We recommend using the epoxy glue 'woodweld' by JB Weld for the best possible adherence of these mounts to wooden chairs. This glue is available to buy alongside our shockmounts.
The shock mount measures 45mm x 45mm x 15mm.
1 - Clean and sand area of original shock mount in preparation
2 - Gently sand back of new shock mount to make slightly abrasive
3 - Clean back of new shock mount and area of application with acetone or white spirit.
4 - Mix and apply a wood epoxy glue (JB Weld is one such brand) to the shockmount
5 - Put shock mount into place and use a clamp for at least 24 hours
We do not take responsibility for any failed fitments. We would always suggest using professionals to fit them.